Create a pool table yourself

Buy a pool table ready is very expensive, especially since the price of good varieties of which ranges between 500 - 5000 dollars (1875-18751 SAR) and it depends on the quality of the industry and the wood used in their manufacture and the manufacture of special specifications makes them more expensive, so it may be best you\ا yourself where you can manufacture according to your desire. 
, 
Alodaut and materials 
Nails - Hammer - Chisels - screws pistol - sandpaper sand - Drill - tape measure - for iPad - saw electric - publish wood table - wood glue - 5 - 10 large wooden planks - networks for making the balls. 
Dimensions 
Table surface 3.5 x 7 feet. 
The feet of the table (4), up 1 foot. 
, 
Steps 
1) Measure the room area home that you want to put the table in. Make sure you have enough space to put the table with a distance of 4 feet further from all sides, and then select an area of ​​the table you want in their industry, and usually come billiard tables in 3 sizes, 7 feet (78 x 39-inch) and 8 feet (88 x 44 inches) and 9 feet (100 x 50 inches). 
, 
2) Disconnect the flat wood board dimensions that you want for your table, and measurement and education place the length and width of the table, using the table saw cut electric plank and make sure a flat piece of wood and edges Besnfrh the parties until smooth. 
, 
3) Disconnect the introduction of the balls in the holes using a circular saw gaps and make the holes diameter 4.5 and 5 inches in the 4 corners of the board and then make the wooden two holes in the middle along the sides of the board and edges Besnfrh the cut and make sure they become soft. 
, 
4) Cut table legs of the wooden beams that you have bought and make them the same length and size, and you can do some digging where to give it the form of aesthetic and through drawing in pencil on the surface of the man-wood, then use Ozmila and a small hammer to follow the lines drawn and making digging gummy, after the completion Clean the drilling location. 
, 
5) Place the legs after the completion of the industry down the plank that you Besnaath, as a table surface, and move it near the center of the table a distance of 6 inches to avoid conflict with the dig balls backgammon, and install the legs from the summit below the surface with 3 screws for each man. 
, 
6) 6 making the wooden strips 50 inches Khawwav wide for a billiard table and cut in strips and then proved drilling locations strips around the edges of the table using screws placed at equal distances from each other about 12 inches. 
, 
7) Put glue on the surface of the table so the edges, then place a layer felt above the surface of the table and be sure to be glued to the surface without being there are spaces between the felt and the surface of the table or complex parts makes the surface is level, and press on the surface of felt for air discharge and be sure to be Felt covered up edges and بثنيه from the surface to cover bottom and then secure it staples to ensure stability. 
, 
8) Use screws to install gun digging balls network table and make sure that the breadth of each hole so that at least nine 4 balls. 
, 
9) Place the balance of water on the surface of the table to make sure they are on one level and not tilted, and if I found out that the table tilted from one side and the need to increase the height to make it equal, place a wedge down the feet of the table that you need to go up a little bit and re-measuring the balance to make sure they become completely equal. 
, 
10) after the completion of the industry table Bring a brown paint or black or color you prefer, and paint the table carefully and be sure to not fall on the felt and paint Enjoy your billiard table.